Off to new heights.

After the day off yesterday, which was really relaxing and nice (and oh so needed!), I'm now itching to get downstairs and full of sawdust again.

I could not resist to test for the height of the wheel and how it would turn yesterday, though, so I clamped it to the bookshelf and took a turn or three... and figured out that the axis height that I had intended was too low by about 12 cm. So the wheel is now off to new heights, so to say - I have adjusted the height in the plan... good thing that there was some room for adjustments left in all the pieces that I prepared until now.

So the next steps are: mounting the feet in the main board, mounting the wheel to the wheel stand, and then putting the wheel stand into the main board via mortise and tenon. Exciting prospects!